Safety Information – Be sure to use the specified power source. If you come to a situation that this LED is blinking in red, a more serious problem has occurred. It can be used to test the behavior of several settings in the printer, and to print in many different ways, with different resources; it can also be used to test different settings if a special application requires a fine tuning of the printer. Paper Width mm You must also adjust the paper roll spacer located inside the printer, as described below: Command Set Configuration In this section you can configure the command set that the printer will recognize when receiving printer commands from the host system.
|Date Added:||11 November 2013|
|File Size:||28.95 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
With the COM 1 Card, the easiest way is to grab and pull the connector of the interface cable with the screws fastened to the interface card; the whole interface card should come out.
Bematech MP TH Quick Start User Manual | 48 pages
Where to bfmatech the printer The MP TH should be placed on a plain, stable surface located indoors or protected from the weather. Leds This LED is used to bematehc information on the current printer status. Adjusting The Beematech Width Keep it stored if in the future you will need to change back to a different paper width. Disconnect the printer from the PC and from the power supply Unscrew the cartridge from the rest of the printer.
Connections It is possible to connect up to three cables to the printer. Introduction The MP TH is a fast high quality POS printer using the thermal technology for printing, being compatible with most cash systems on the market. These features optimize the ease of service and reduce the costs of printer down-time and maintenance.
Command Set Configuration In bemarech section you can configure the command set that the printer will recognize when receiving printer commands from the host system. If you must leave printouts in the printer, be aware that more than 15 tickets will increase the risk of blocking the paper exit and a paper jam may occur.
Bematech Mp-4000 Th Fi SM SP Thermal POS Receipt USB Printer
This manual also for: By pressing ‘print’ button you will print only current page. Print Width mm Chapter 1 If any parts are missing or damaged, please contact your dealer for assistance.
In this section, you can configure the paper width used and the print width adopted by the software in the printer. Who should read this manual? Red LED blinking 8 times — Print Mechanism Error On bematech mp print initialization, m; status of the print head and the paper feed motor picture below are verified. Don’t show me this message again. How this bmeatech is organized?
Page of 55 Go.
Cash Drawer Interface Disconnect the printer from the PC and from the power supply Unscrew the cartridge from the rest of the printer.
Try to avoid disassembly, assembly and unnecessary adjustments on the MP TH parts that are working properly; 2. Several settings can be changed in the Printer Menu. The correct position to connect this cable bematech mp on the CN4 connector as shown on the image on the side.
Chapter 1 – “Getting Started” Adjusting the Paper Width Table of Contents Add to my manuals Add. To avoid that, verify once a year that the sensor surfaces are unobstructed.
When pulling it back, the control board bematechh disconnected from the connection board, located on the frontal portion of the printer. If the level is low, the printer can receive data.
You can configure to: The correct position to connect this cable is on the CN4 connector as shown on the image on the side. Bematech mp 33 After disconnecting the plastic chassis, just pull up the back side to loosen the frontal part.
Chapter 2 MP TH. No part of this publication may be copied, reproduced, adapted or translated without the prior written permission of Bematech S.